Canceled Plastic Cases for Poker and/or Bridge Size Decks (1 Viewer)

Status
Not open for further replies.

RainmanTrail

Straight Flush
Joined
Dec 21, 2015
Messages
9,969
Reaction score
24,825
Location
CA
Rating - 100%
162   0   0
I'm looking for at least 2, but preferably 4 or more of the single deck plastic cases for either bridge or poker sized decks.

I'd like the "slider" cases that caragails used to sell, or something similar to these below:

https://www.kardwell.com/page/KII/CTGY/POKER-SD-BOXES

Thanks :)


deck-plastic-poker-card-box-single.jpg
 
You could always buy the 100 from kardwell and have a GB here. I'd grab a couple.
 
I'm looking for at least 2, but preferably 4 or more of the single deck plastic cases for either bridge or poker sized decks.

I'd like the "slider" cases that caragails used to sell, or something similar to these below:

https://www.kardwell.com/page/KII/CTGY/POKER-SD-BOXES

Thanks :)


deck-plastic-poker-card-box-single.jpg
I think hobby lobby sells something like these for sport cards. Fit poker size for sure.

http://www.hobbylobby.com/Crafts-Ho...ng/Card-Collecting/Trading-Card-Boxes/p/21925

In my area you can use a coupon for 40% off to make these pretty reasonable.

2 boxes in each package.
 
Thanks for the responses guys.

The ones made for baseball cards are actually a little bit larger than a deck of cards. There's a fair amount of play inside those cases when used with poker decks. Does anyone know if the ones caragails used to sell had the same issue, or were they made with a tighter fit for poker cards?
 
I purchased the ones from Caragails few years back. Then found the exact same ones as in the Amazon link.
Yes, they have a bit of wiggle room for poker-size cards, but I would say they fit pretty well.
I do wish there was a better fitting bridge-sized version though.
 
If it helps, I just used a digital caliper on the bottom half of the slider case (interior dimension):
Approximately 91.5mm x 65.5mm, give or take a touch with plastic inconsistencies.
 
@David O posted a link awhile back for a pretty good source of both poker and bridge size cases. Don't have it handy, but he probably has it....
 
If it helps, I just used a digital caliper on the bottom half of the slider case (interior dimension):
Approximately 91.5mm x 65.5mm, give or take a touch with plastic inconsistencies.

Thanks. These must be the same cases as the ones for baseball cards then (as made by Ultra PRO and BCW). I have some of these for my baseball cards, but they're pretty loose for my poker decks. Too loose for my OCD, haha. I'm gonna try out the ones on eBay and see how they fit.

I wonder how much interest there'd be from the community if we went for the minimum order of 100 cases for the one shown in the OP? They appear to have a nice fit in the image.
 
Status
Not open for further replies.
Back
Top Bottom