Want to order DEALER BUTTON with high resolution print. (1 Viewer)

[Zema1111]

I need help finding a manufacturer capable of producing high-definition dealer buttons. I'm looking for buttons that are 60mm or larger and can be made of any type of material. I'm currently using a PCF dealer button, and I love its texture and production quality. Please provide suggestions. Thank you.

 

[allforcharity]

Ceramic dealer buttons from BR Pro is probably what you're looking for. Tried and true for dozens and dozens of custom PCF orders. Contact them!

 

[DerFabo]

For a ceramic Db this could be to detailed. I think you should go the acrylic route. But then you need to cancel the print in the rolling edge...

Very cool design btw!

 

[Colquhoun]

The acrylic buttons are capable of the highest resolution I’ve seen yet.
The issue I see is that your graphics are very close to the edge. Regardless of who prints this, you’ll need to account for the possibility of a shift of 1/16”, possibly a bit more. I generally don’t like anything important to go any closer than 1/8” to 3/16” from an edge. If it’s a circle, maybe even more space, because if that’s off by just a little, it will be noticeable.
If you made everything a bit smaller, and that gray dealer ring was further from the edge, it may be ok. It’s fine if the orange and dark gray spots bleed over the edge, but if that ring is too close and it prints slightly off center, it will be definitely noticeable.

 

[Zema1111]

The acrylic buttons are capable of the highest resolution I’ve seen yet.
The issue I see is that your graphics are very close to the edge. Regardless of who prints this, you’ll need to account for the possibility of a shift of 1/16”, possibly a bit more. I generally don’t like anything important to go any closer than 1/8” to 3/16” from an edge. If it’s a circle, maybe even more space, because if that’s off by just a little, it will be noticeable.
If you made everything a bit smaller, and that gray dealer ring was further from the edge, it may be ok. It’s fine if the orange and dark gray spots bleed over the edge, but if that ring is too close and it prints slightly off center, it will be definitely noticeable.

Thanks, I will keep that in mind once I am ready to go to production.

 

[desselBANE]

I need help finding a manufacturer capable of producing high-definition dealer buttons. I'm looking for buttons that are 60mm or larger and can be made of any type of material. I'm currently using a PCF dealer button, and I love its texture and production quality. Please provide suggestions. Thank you.

View attachment 1306808

Did you end up getting one made?

 

[Zema1111]

Did you end up getting one made?

Yes, ordered from Matsui