Milling too deep? (1 Viewer)

[Johnblue]

Is this milling job too deep for @Gear textured laminated labels?
Any feedback welcome. Thanks.
-j

 

[TX_Golf_N_Poker]

Maybe just a tad?

 

[abby99]

Are you saying that's not a prototype for @Gear's new CIC* line?

* Coin-in-Center

 

[TheOffalo]

That's so sea captains can put their chips on a ship's steering wheel.

 

[Anthrax]

@Dingdingding what do you think?

 

[LeGold]

If you go for 1" labels, you're good!

 

[Dingdingding]

My girlfriend helped me out with milling a few months ago...

Did she mill for you as well?

 

[Colquhoun]

Perfect cic candidates!

 

[LowerBama1714]

I’d buy a few sets to make earrings for my girls…

 

[Sprouty]

My girlfriend helped me out with milling a few months ago...View attachment 1244725

Did she mill for you as well?

She made you c-rings for your dingdingdings.

 

[MeridianFC]

It’s fine.

 

[allforcharity]

Just saying, this cannot happen with the bottom router method.

 

[machinelf]

Big Blue Approved

 

[krafticus]

You can go deeper ...
(Yes, I know where this is going)

 

[allforcharity]

You can go deeper ...
(Yes, I know where this is going)

Going deeper requires a medical practitioner's license in the state of Maryland.

 

[Deklan]

Too deep? I doughnut know.

 

[dmoney]

I called mine…

“All in for less” View attachment 823498

 

[Littleluck55]

You can go deeper ...
(Yes, I know where this is going)

I can mill faster, but I can’t go any deeper.