Ultrasonic Chip Cleaning (26 Viewers)

[GoJo_Dingo]

I bought a brush off amazon that I found much easier to use than a toothbrush for scrubbing edges. Would recommend something similar to anyone doing the same. Just make sure whatever you get isn't too stiff or abrasive. Was advertised as boar bristle but idk for sure.

View attachment 1407849

BAM!

Your ultimate chip cleaning brush, Costco!
You're welcome.

https://www.costco.com/rubbermaid-p...kit-.product.4000250879.html?origin=serp_auto

 

[maxim_666666]

My attempt at soaking the chips for 10-15 minutes in detergent did wonders for the Paulson. They came off incredibly easily with a brush. I'm guessing 5 minutes and a light ultrasonic bath would get them perfect. This chip isn't even oiled.

The ASM chips became soft and the top layer became loose and burnt out.
The hot stamp disappeared because I ran my finger over it and it came off along with the top layer of clay.
Black turned grey..

Retro green just became green.

Although, I must say that the oil helped a little. But, the surface remained porous. .

I don't know what it is, but it damages ASM/CPC chips.

 

[TX_Golf_N_Poker]

My attempt at soaking the chips for 10-15 minutes in detergent did wonders for the Paulson. They came off incredibly easily with a brush. I'm guessing 5 minutes and a light ultrasonic bath would get them perfect. This chip isn't even oiled.
View attachment 1412731
View attachment 1412732
View attachment 1412733
The ASM chips became soft and the top layer became loose and burnt out.
The hot stamp disappeared because I ran my finger over it and it came off along with the top layer of clay.
Black turned grey..
View attachment 1412734
View attachment 1412743View attachment 1412744

Retro green just became green.
View attachment 1412735
Although, I must say that the oil helped a little. But, the surface remained porous. .
View attachment 1412754
I don't know what it is, but it damages ASM/CPC chips.
View attachment 1412737
View attachment 1412821

That is scary what happened to that DieCar. I don't know if it is said enough in here that what works for Paulson, may not work for CPC / ASM or other older chips.

With that said, what is the preferred method for cleaning these older, non-Paulson chips? I just bought an 1800 chip limit set of DieCars. The yellow solids are a bit grungy, and hot stamps have begun to wear. I'd like to clean up the chips, but not create any further wear on the stamps.

 

[ski_ex5]

That is scary what happened to that DieCar. I don't know if it is said enough in here that what works for Paulson, may not work for CPC / ASM or other older chips.

I think it’s stated very clearly in the OP. Some people read it, and some people didn’t.

 

[maxim_666666]

That is scary what happened to that DieCar. I don't know if it is said enough in here that what works for Paulson, may not work for CPC / ASM or other older chips.

With that said, what is the preferred method for cleaning these older, non-Paulson chips? I just bought an 1800 chip limit set of DieCars. The yellow solids are a bit grungy, and hot stamps have begun to wear. I'd like to clean up the chips, but not create any further wear on the stamps.

View attachment 1422515
View attachment 1422519

Only a toothbrush and mild soap will help here. Perhaps ultrasound with distilled water (or water without micro-air bubbles) and mild soap.

On this forum it is a crime to buy 1800 chips and not take a group photo!

 

[TX_Golf_N_Poker]

I think it’s stated very clearly in the OP. Some people read it, and some people didn’t.

Seriously dude? This is an 11 year old thread with 57 pages of posts. And you're saying everything we need to know is in the first post? Yeah, right...

 

[TX_Golf_N_Poker]

Only a toothbrush and mild soap will help here. Perhaps ultrasound with distilled water (or water without micro-air bubbles) and mild soap.

On this forum it is a crime to buy 1800 chips and not take a group photo!

Thanks! Those are seller pics. I will absolutely take group photos once I have possession of the chips.

In the meantime, maybe this photo from the seller will do? I bought 1600 of the yellow and 200 of the blue/red on the far right.

 

[ski_ex5]

This is an 11 year old thread with 57 pages of posts. And you're saying everything we need to know is in the first post? Yeah, right...

No. I’m not saying that everything you need to know is in the first post.

I only said that the fact that Burt Co./ASM/CPC chips are damaged by the Lundmark “TSP” (and others) is stated in the original post.

 

[allforcharity]

Clean chips are good chips!

 

[GoJo_Dingo]

Whoooooa!

 

[Rooster410]

Any concerns with ultrasonic cleaning Paulson hot stamp chips? I do not want to jeopardize the starburst stamps

 

[allforcharity]

Any concerns with ultrasonic cleaning Paulson hot stamp chips? I do not want to jeopardize the starburst stamps View attachment 1433463

No concerns. My post directly above yours was 50% hot stamped chips.

 

[springbox]

Any concerns with ultrasonic cleaning Paulson hot stamp chips? I do not want to jeopardize the starburst stamps View attachment 1433463

Same concern as hand cleaning them, just make sure you don't use a detergent/cleaner that messes with the foil. Always best to test your method with a sacrificial chip if you're not sure.